Microtek ScanMaker E3 SCSI Manuel d'utilisateur télécharger pdf

How to keep ScanMaker E3 to work with ScanWizard 2.60 under Windows XP system

ScanWizard 2.60 is the last version of scanner driver S/W that can support ScanMaker E3 to work

under Windows XP ( 32 bit ) system through SCSI / EPP ( Printer Port ) connectivity..

The procedure to keep

ScanMaker E3 to work with ScanWizard 2.60 under Windows XP ( 32

bit ) system through SCSI connectivity is as follows.

Step 1. Make sure ScanWizard 2.60 is installed into PC Windows XP ( 32 bit ) system with an

administrator’s privilege.

Step 2. Power up ScanMaker E3 until ScanMaker E3 go ready ( Status LED shall light up in Green

steadily ), and then check the pointer of SCSI Rotary ID Switch is positioned at 6, finally,

make a SCSI cable connection between PC and ScanMaker E3.

Step 3. Check the linking information of ScanMaker E3 in Device Manager from Start  Control

Panel  System  Hardware  Device Manager  Imaging devices  Microtek Scanner

E3 as the picture below..

Check the SCSI Card information of AVA-2903 at SCSI and RAID Controllers in Device

Manager from Start  Control Panel  System  Hardware  Device Manager  SCSI

and RAID controllers  Adaptec AIC-7850 PCI SCSI Controller as the picture below.

Green LED is a status

LED of ScanMaker E3.

Here is a 25 pin

SCSI connector.

Here is a 50 pin

SCSI connector.

Here is a 15 pin

TMA connector.

Here is a 50 pin to 25 pin SCSI

Cable for ScanMaker E3

The pointer of SCSI ID Rotary

Switch is at No.6 now.

1 2 3 4

Page 1

1How to keep ScanMaker E3 to work with ScanWizard 2.60 under Windows XP system ScanWizard 2.60 is the last version of scanner driver S/W that can sup

Page 2

2 It is because ScanMaker E3 has never claimed the logo certification of WIA driver for Windows XP system from Microsoft before. Hence, if Windows

Page 3

3 Step 4. Click to execute utility : Scanner Test from Start  All Programs  Microtek ScanWizard for Windows  Scanner Test. Here is a SC

Page 4

4Step 5. You can import Twain driver of Microtek ScanWizard ( 32 bit ) as the picture below, and then do Reflective scan with ScanMaker E3 in Sc

Pas de commentaire

Microtek ScanMaker E3 SCSI Manuel d'utilisateur