Microtek ArtixScanDI 2020 Plus Manuel d'utilisateur télécharger pdf (Page 14)

14 ArtixScan DI 4020 Plus/ArtixScan DI 2020 Plus User's Manual

Notice for Calibration Data

It is strongly recommended that you should duplicate a copy of calibration data for your scanner

after installing the software in case if you loose the Microtek Software CD/DVD or a newer

version of ScanWizard DI is required in the future. You can find the calibration data in either of

these two locations:

• After the software has been installed, go to the drive where it is installed and look for a folder

named “Scanners”. Double-click “Scanners” to open it, look for a data named

“ADFCalData86_xxxx.dat” for ArtixScan DI 4020 Plus or “ADFCalData87_xxxx.dat” for

ArtixScan DI 2020 Plus, and then copy it out from the folder.

• Look for the same folder “Scanners” in your Microtek Software CD/DVD, open it to look for

a data named as same as that mentioned above, and then copy it out from the folder.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Pas de commentaire

Microtek ArtixScanDI 2020 Plus Manuel d'utilisateur Page 14