Microtek CX4 Manuel d'utilisateur télécharger pdf (Page 36)

Auto Configuration

Entering the “Auto Config.” icon under OSD menu, the projector will automatically

select the frequency and image position for the analog signal.

Information

Entering the “Information” icon under OSD menu, it will present the state of the

image: current resolution (1024*768 or 720*240), H

(horizontal scanning

frequency)

& V

(vertical scanning frequency) and lamp age (the consumed hours).

Miscellaneous

Entering the “Miscellaneous” icon under OSD menu, you can restore the revised

settings to the defaults. You may also make adjustments for OSD Timeout, OSD

Position, Dithering, Native Mode and Auto Color.

In the Miscellaneous box, there are “Factory Reset”, “OSD Timeout”, “OSD

Position”, “Dithering”, “Native Mode”, ”Color Temperature” and “Auto Color” bars.

 Select the “Factory Reset” bar, all the settings you have revised will be

restored to the defaults which are set up before shipment of the projector.

 Select the “OSD Timeout” bar, the duration of OSD box displayed on the

image can be adjusted from 5 seconds to 60 seconds; i.e. the time of OSD

box displayed on the image will last for min. 5 seconds to max. 60 seconds.

(The duration will be extended by 5 seconds.)

 Select the “OSD Position” bar, you may adjust the position of the OSD box

on the image.

 Select the “Native Mode” bar, the projector won’t compress or increase the

pixels but present the image in the original resolution of the input signals.

For example, when the input signal is in 800*600 pixels and entering “Native

Mode”, the image will remain in 800*600 resolution, not 1024*768

resolution. (Note: The resolution of this projector is 1024*768 pixels, XGA.)

 Select the ”Color Temperature” bar to adjust the whiteness of a displayed

image. When “Color Temperature” bar move to left, the color of displayed

image will become bluer. When “Color Temperature” bar move to right, the

color of displayed image will become reder.

 Select the ”Lamp Life Rest” bar select “Yes” when a new lamp is replaced to

reset the counter of the lamp life back to the beginning. This setting is to

make sure that the projector records a proper update of the life of the newly

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 54 55

Pas de commentaire

Microtek CX4 Manuel d'utilisateur Page 36